BT STUDIO 1500 - Manual (Page 54)

54
BT Studio 1500 – Edition 3 – 27.07.04 – 5876
Using additional bases
On the base:
7. Press and hold to put the base into registration
mode.
The base beeps and the In use light flashes while the
handset is registered.
Once registered you will hear a confirmation tone and
the next available handset number is allocated and
shown in the display.
Selecting a base to use
If your handset has been registered to more than one
base you can select which one it uses.
1. Press .
2. Press or until REGISTER is displayed then
press .
3. Press or until SELECT BASE is displayed then
press .
4. All bases that your handset is registered to will be
displayed, e.g. BASE 1 2 3 4
The base that you are currently registered to will flash.
5. Enter the number of the base you want to use.
Menu
Vol
Menu
Vol
Menu
Page If registration is unsuccessful, after
1 minute, the handset will display
the list of registered bases and you
can try again or select another
base to use.
If you are in an environment
where there is a lot of electrical
interference you may experience
difficulty registering to a base.