B&B Electronics 1140 - Manual (Page 3)

Documentation Number 11401198 Manual 1
B&B Electronics -- PO Box 1040 -- Ottawa, IL 61350
PH (815 433-5100 -- FAX (815) 433-5105
1.0 WARRANTY INFORMATION
B&B Electronics warrants all Model 1140 components to be free
from defects, and will, at our option, repair or replace the product
should it fail within one year from the first date of shipment.
This warranty is limited to defects in workmanship or materials, and
does not cover customer damage, abuse or unauthorized
modification. If this product fails or does not perform as warranted,
your sole recourse shall be repair or replacement as described
above. Under no condition shall B&B Electronics be liable for any
damages incurred by the use of this product. These damages
include, but are not limited to, the following: lost profits, lost savings
and incidental or consequential damages arising from the use of or
inability to use this product. B&B Electronics specifically disclaims all
other warranties, expressed or implied, and the installation or use of
this product shall be deemed an acceptance of these terms by the
user.
1.1 RADIO AND TV INTERFERENCE
The Model 1140 generates and uses radio frequency energy,
and if not installed and used properly—that is, in strict accordance
with the manufacturer's instructions—may cause interference to
radio and television reception. The Model 1140 has been tested and
found to comply with the limits for a Class A computing device in
accordance with the specifications in Subpart J of Part 15 of FCC
rules, which are designed to provide reasonable protection from
such interference in a commercial installation. However, there is no
guarantee that interference will not occur in a particular installation.
If the Model 1140 does cause interference to radio or television
reception, which can be determined by disconnecting the RS-232
interface, the user is encouraged to try to correct the interference by
one or more of the following measures: moving the computing
equipment away from the receiver, re-orienting the receiving
antenna and/or plugging the receiving equipment into a different AC
outlet (such that the computing equipment and receiver are on
different branches).