Philips Lámpara de infrarrojos InfraCare - Manual (Page 9)

Note: Practice has shown that a few short treatments a day produce a better result than one longer
treatment.
If in doubt, always consult your doctor!
using the infracare
1 Put the mains plug in the wall socket.
The on/off button (A) and the timer buttons (D) blink for 1 minute, the maximum intensity
button (B) lights up and 00 blinks on the display (Fig. 16).
 Set the desired treatment time by pressing the + or - timer button. Keep the button pressed
to adjust the time more quickly.
 Adjust the light intensity of the lamp by pressing one of the intensity buttons. If you do not
press any of these buttons, the lamp will operate at its default setting, which is maximum
intensity.
 Switch the appliance on by pressing the on/off button.
5 If you want to interrupt the treatment, press the pause button (C) (Fig. 16).
The lamp goes out, but the remaining treatment time is stored in the memory of the appliance.
To resume the treatment, press the pause button again.
6 To change the treatment time and light intensity during the treatment:
Press the + or - timer button to change the treatment time or one of the intensity buttons to
change the light intensity.
7 The appliance automatically switches off after the set time has elapsed.
Note: During the last minute of the set time 01 blinks on the display.
cleaning
Unplug the appliance and let it cool down for about 15 minutes before you clean it.
Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone
to clean the appliance.
1 Clean the lamp housing, the pedestal and the base with a moist cloth. Do not let any water
run into the appliance.
 You can clean the outside of the filter with a soft cloth sprinkled with some methylated
spirits.
storage
1 Unplug the appliance and let it cool down for about 15 minutes before you store it.
 Turn the height adjustment ring anticlockwise, push the lamp housing down and then lock it
into position by turning the ring clockwise (Fig. 12).
Always lift or carry the appliance by its pedestal (Fig. 17).
Note: Store the InfraCare in a dry place.
replacement
Filter
The filter protects against exposure to undesired light.
If the filter is damaged or broken, do not use the appliance anymore. Contact the Philips
Consumer Care Centre for information.
,
-
-
,
EnglisH