Black & Decker GH710 - Manual (Page 8)

REPLACEMENT ACCESSORIES
Use Black & Decker replacement spool Model No. DF-065.
Reload nylon line (either bulk or prewound replacement spool) as
shown in this manual.
• USE ONLY .065 inch (1.65 mm) DIAMETER ROUND NYLON
LINE. Do not use serrated or heavier gauge line, as they will
overload the motor and cause overheating. This line is available
at your local dealer or authorized service center.
• Other replacement parts (guards, spool caps, etc.) are available
through Black & Decker service centers. To find your local service
location call: 1-800-544-6986 or visit www.blackanddecker.com.
WARNING:
The use of any accessory not recommended by
Black & Decker for use with this tool could be hazardous.
REPLACING THE SPOOL (FIGURES L & M)
• Unplug the tool.
• Depress the tabs (a) and
remove the spool cap (b)
from the spool housing (c) in
the trimmer head (figure L).
• For best results, replace
spool with Black & Decker
model # DF-065.
• Grasp empty spool (d) with
one hand and spool housing
with other hand and pull
spool out. If lever (e)
(figure M) in base of housing
becomes dislodged, replace
in correct position before
inserting new spool into
housing.
• Remove any dirt and grass
from the spool and housing.
• If desired, pull the wire edge guide (7)
out from the motor housing until it clicks
into the locked position as shown in
figure K and position the trimmer above
the surface as shown in figure K.
• Return to the trimming position by
loosening the lock collar (9) and rotating
the lower housing back 180°. The tool will
lock in the trimmer position. When using
the tool, retract the wire
edge guide to the original
position, out of the way.
CUTTING LINE / LINE FEEDING
Your trimmer uses .065 inch (1.65 mm) diameter, ROUND
nylon line. During use, the tips of the nylon lines will become
frayed and worn and the special self feeding spool will
automatically feed and trim a fresh length of line. Cutting line will
wear faster and require more feeding if the cutting or edging is
done along sidewalks or other abrasive surfaces or heavier
weeds are being cut. The advanced automatic line feeding
mechanism senses when more cutting line is needed and feeds
and trims the correct length of line whenever itʼs required. DO
NOT BUMP unit on ground in attempt to feed line or for any other
purposes.
K
7
L
h
i
a
d
c
b
b
Replacement
spool
Model #
DF-065
8