Philips Mando a distancia universal - Manual (Page 6)

Setting the remote control
This is only necessary if your brand does not respond to the SRU160.
If that is the case, the SRU160 does not recognize the brand and/or model
of your brand and you need to program the remote control to do so.
The example below (TV) instructs you how to do this.
You can repeat the same steps when setting the SRU160 for your
DVD player/recorder.
You can set the remote control either automatically or manually.
Automatically setting the remote control
The remote control will now automatically search for the right code for
your brand.
Example of TV:
The keys between brackets are used for setting the SRU160 for your
DVD player/recorder.
1 Make sure the TV is switched on and select a channel using the
original remote control or the keys on the TV
(for example channel 1).The SRU160 emits the ‘switch off TV’ signal
for all models of TV that are stored in the memory.
• If the device is a DVD player/recorder, insert a disk and start playback.
2 Then keep keys VOL + and PROG +
(
5 and 6) on the SRU160 pressed
simultaneously for three seconds, until the
LED flashes twice and then remains lit.
3 Press and hold the TV (DVD) key of
the SRU160.
6 ENGLISH
SRU160_A6_v2.qxd 25-05-2005 16:18 Pagina 6