Brother DCP 8060 - Manual (Page 31)

General setup
19
3
Volume Settings
3
Beeper volume
3
When the beeper is on, the machine will beep
when you press a key and make a mistake.
You can select a ring volume level from a
range of settings, from High to Off.
a
Press Menu, 1, 3.
13.Beeper
a Low
Med
b High
Select ab & OK
b
Press a or b to select Off, Low, Med or
High
. Press OK.
c
Press Stop/Exit.
Ecology features
3
Toner save
3
You can save toner using this feature. When
you set toner save to On, print appears
lighter. The default setting is Off.
a
Press Menu, 1, 4, 1.
14.Ecology
1.Toner Save
a On
b Off
Select ab & OK
b
Press a or b to choose On (or Off).
Press OK.
c
Press Stop/Exit.
Note
We do not recommend Toner Save for
printing Photo or Gray Scale images.
Sleep time
3
Setting the sleep time reduces power
consumption by turning off the fuser while the
machine is idle.
You can choose how long the machine must
be idle (from 00 to 99 minutes) before it goes
into sleep mode. When the machine receives
computer data or makes a copy, the timer will
be reset. The default setting is 05 minutes.
While the machine is in sleep mode the LCD
will display Sleep. When printing or copying
in sleep mode, there will be a short delay
while the fuser warms up.
a
Press Menu, 1, 4, 2.
14.Ecology
2.Sleep Time
Sleep Time:05Min
Enter & OK Key
b
Enter the length of time the machine is
idle before entering sleep mode
(00 to 99). Press OK.
c
Press Stop/Exit.
To turn off sleep mode, press Secure and
Job Cancel at the same time in b.
Press a or b to select Off (or On).
Press OK.
Note
When you turn off sleep mode, the setting
will take effect the next time the machine
copies, prints or is turned off and on.