Brother DCP 8060 - Manual (Page 71)

Troubleshooting and routine maintenance
59
Error messages
C
As with any sophisticated office product, errors may occur. If this happens, your machine will
identify the error and display an error message. The most common error messages are shown
below.
Error Message Cause Action
Cooling Down
Wait for a
while
The temperature of the drum unit or
toner cartridge is too hot. The
machine will pause its current print
job and go into cooling down mode.
During the cooling down mode, you
will hear the cooling fan running
while the LCD shows Cooling
Down
, and Wait for a while.
Make sure that you can hear the fan in the
machine spinning and that the exhaust outlet
isn't blocked by something.
If the fan is spinning, remove any obstacles that
surround the exhaust outlet, and then leave the
machine turned on but do not use it for several
minutes.
If the fan is not spinning follow the suggestions
below.
Turn off the machine's power switch and then
turn it on again. If the error message continues
leave the machine for several minutes and then
try it again.
Cover is Open
The front cover is not closed
completely. Close the front cover of the machine.
The fuser cover is not closed
completely. Open the back cover, and then open the fuser
cover. Remove jammed paper if there is any,
and then close the fuser cover and the back
cover.
The document cover is not closed
completely. Remove the document from the scanner glass,
and then close the document cover.
Doc. Cover
Open
The document cover is not closed
completely. Remove the document form the ADF, remove
the document on the scanner glass, and then
close the document cover.
Document Jam
The document was not inserted or
fed properly, or the document
scanned from the ADF was too
long. See Document jams on page 62 or Using the
ADF on page 10.
Drum Near End
The drum unit is near the end of its
life. Use the drum unit until you have a print quality
problem; then replace the drum unit with a new
one.
See
Replacing the drum unit (DR-520) on page 76.
The drum counter was not reset
when a new drum was installed. 1. Open the front cover, and then press
Clear/Back.
2. Press 1 to reset.
Duplex
Disabled
(DCP-8065DN only)
The duplex tray is not installed
properly. Remove the duplex tray and install it again.