Bissell 6590 - Manual (Page 12)

12
Grasp Rotating Floor Brush at both ends and lift.
Clean strings, hair and other debris from Rotating Floor
Brush, paying particular attention to brush ends.
Clean strings, hair and other debris from Motor Pulley and
Drive Belt areas.
Check Drive Belt carefully for wear, cuts or stressed areas.
Check Air Passageway for obstructions. Remove debris
from this area.
Unplug cleaner from electrical outlet.
With Rotating Floor Brush removed from vacuum cleaner
(Steps 1-4 of check Rotating Floor Brush and Drive Belt),
grasp old Drive Belt and remove from Motor Pulley.
Discard old Drive Belt.
Place new Drive Belt over Motor Pulley and stretch other end
over Rotating Floor Brush in the space between the bristles.
Place ends of Rotating Floor Brush down into slots on
sides as shown.
Turn Rotating Floor Brush by hand several times in the
direction of Motor Pulley. If properly installed, Drive Belt
will center itself on Rotating Brush crown.
Reposition Brush Cover and screws. Tighten screws securely.
Unplug cleaner from electrical outlet
Using a screwdriver, remove the two screws as shown
and lift off the lens.
Remove the bulb from the socket by pushing in gently
and turning it counterclockwise. Install the new bulb by
pushing it gently into the socket and turning clockwise.
Reposition lens and secure with the two screws.
Select Models Only
If a clog is present, unscrew the two screws in the back of
the TurboBrush to remove the faceplate and clear any
obstructions.
1.
Replace Lightbulb
2.
3.
4.
Maintaining Optional TurboBrush
Replace Drive Belt
Check Rotating Floor Brush and Drive Belt Continued
1.
2.
3.
4.
5.
6.
4.
5.
6.
7.
8.
Air Passageway
Motor Pulley