Philips BEARDTRIMMER Series 9000 barbero resistente al agua User Manual

Philips Health and hygiene

Advertising
background image

English

introduction

Congratulations on your purchase and welcome to

Philips! To fully benefit from the support that Philips

offers, register your product at www.philips.com/

welcome.

important

Read this important information carefully before you use

the appliance and save it for future reference.

Danger

- Keep the adapter dry (Fig. 1).

Warning

- Check if the voltage indicated on the adapter

corresponds to the local mains voltage before you

connect the appliance.

- The adapter contains a transformer. Do not cut

off the adapter to replace it with another plug, as

this causes a hazardous situation.

- This appliance is not intended for use by persons

(including children) with reduced physical, sensory

or mental capabilities, or lack of experience and

knowledge, unless they have been given supervision

or instruction concerning use of the appliance by a

person responsible for their safety.

- Keep the appliance and its cord out of reach of

children.

- Do not use the appliance in the bath or in the

shower.
Caution

- Always check the appliance before you use it. Do not

use the appliance if any of its parts is damaged or

broken, as this may cause injury.

- Only use this appliance for its intended purpose as

shown in the user manual.

- Use, charge and store the appliance at a temperature

between 5°C and 35°C.

- Only use the adapter or charger supplied to charge

the appliance.

- Make sure the appliance is switched off and

disconnected from the mains before you clean it

under the tap.

- Never immerse the charger in water nor rinse it

under the tap.

- If the appliance is subjected to a major change in

temperature, pressure or humidity, let the appliance

acclimatise for 30 minutes before you use it.

- If the adapter or charger is damaged, always have it

replaced with one of the original type in order to

avoid a hazard.

- Never use compressed air, scouring pads, abrasive

cleaning agents or aggressive liquids such as petrol or

acetone to clean the appliance.

- Maximum noise level: Lc= 75dB(A)

Compliance with standards

- The appliance complies with the internationally

approved IEC safety regulations and can be safely

cleaned under the tap (Fig. 2).

- This Philips appliance complies with all standards

regarding electromagnetic fields (EMF).
Class 1 laser product

- The product contains a class 1 laser guide which

complies with IEC60825-1 (Fig. 3).

- To avoid all risks, point the laser beam away from

your eyes and do not stare directly into the laser

beam (Fig. 4).

Ordering accessories

To buy accessories or spare parts, visit

www.shop.philips.com/service or go to your

Philips dealer. You can also contact the Philips Consumer

Care Centre in your country (see the worldwide

guarantee leaflet for contact details).

Environment

- Do not throw away the appliance with the normal

household waste at the end of its life, but hand it in

at an official collection point for recycling. By doing

this, you help to preserve the environment (Fig. 5).

- The built-in rechargeable battery contains substances

that may pollute the environment. Always remove

the battery before you discard and hand in the

appliance at an official collection point. Dispose of

the battery at an official collection point for batteries.

If you have trouble removing the battery, you can

also take the appliance to a Philips service centre.

The staff of this centre will remove the battery for

you and will dispose of it in an environmentally safe

way. (Fig. 6)
Removing the rechargeable battery

Only remove the rechargeable battery when you

discard the appliance. Make sure the appliance is

disconnected from the mains and the battery is

completely empty when you remove it.
Be careful, the battery strips and housing parts are very

sharp.

1

Check if there are any screws in the back or front

of the appliance. If so, remove them.

2

Remove the back and/or front panel of the

appliance with a screwdriver. If necessary,

also remove additional screws and/or parts

until you see the printed circuit board with the

rechargeable battery.

1

2

3

4

5

6

4222.002.8366.2

BT9295, BT9290, BT9280

Advertising