Philips PerfectCare Azur Fer vapeur User Manual

Page 13

Advertising
background image

Problem

Possible cause

Solution

The iron does not

produce any steam.

There is not enough water in

the water tank.

Fill the water tank (see chapter ‘Preparing

for use’, section ‘Filling the water tank’.

The steam slider is set to ‘no

steam’.

Set the steam slider to MAX (see chapter

‘Preparing for use’, section ‘Steam settings’).

The iron is not hot enough yet

to produce steam.

Wait until the SmartLight has stopped

flashing and lights up steadily.

The iron does not

produce a steam boost.

You have used the steam boost

function too often within a very

short period.

Continue ironing in horizontal position

and wait a while before you use the steam

boost function again.

The iron is not hot enough yet

to produce a steam boost.

Wait until the SmartLight has stopped

flashing and lights up steadily.

Water droplets drip

onto the fabric during

ironing.

You have not closed the water

tank lid properly.

Press the lid until you hear a click.

You are ironing while the

SmartLight is blinking.

Wait until the SmartLight lights up steadily

before ironing.

You have put a chemical into the

water tank.

Rinse the water tank and do not put any

perfume or chemical into the water tank.

The iron leaves a shine

or an imprint on the

garment.

The surface to be ironed was

uneven, for instance because

you ironed over a seam or a

fold in the garment.

The iron is safe to use on all ironable

garments. The shine or imprint is not

permanent and disappears when you wash

the garment. Avoid ironing over seams or

folds. You can also place a cotton cloth over

the area to be ironed to avoid imprints.

EnGlish

13

Advertising