Bissell 3920 - Manual (Page 7)

Handle positions
Press the handle release pedal, located on the lower
left side of the vacuum, with your foot to place your
vacuum into one of three cleaning positions.
1. Upright – For storage and above floor
cleaning with tools.
2. Normal Cleaning – Press handle release
pedal once. Position used for most
household floor cleaning tasks.
3. Low Cleaning – With the vacuum in normal
cleaning position, press handle release pedal
again. Use for reaching under low furniture
such as tables, chairs or beds.
Height adjustment
The powerfoot/rotating floor brush on your vacuum
can be adjusted to clean several floor surfaces.
NOTE: For optimal cleaning performance,
adjust to the lowest practical setting. If
your cleaner is difficult to push, adjust to
the next higher setting.
1. Turn height adjustment knob to desired setting.
Bare Floor For non-carpeted,
indoor surfaces
Lowest Setting For short pile carpets
Medium Setting For short and medium
pile carpets
Highest Setting For plush pile carpet
Pet Hair Lifter
Use to pick up pet hair from carpeted surfaces. Just
vacuum like you normally would. The vacuum will
grab pet hair when you pull back and it will release
hair and suction it up when you push forward.
NOTE: Turn vacuum off before you flip up or
flip down the Pet Hair Lifter.
1. To vacuum carpeted surfaces, make sure
vacuum is in upright position and flip down
the Pet Hair Lifter until it clicks into place on
the front of the foot.
2. To vacuum non-carpeted surfaces, flip up the
Pet Hair Lifter by pushing the yellow release
button. This will flip the Pet Hair Lifter up and out
of the way.
O
perations
7
w w w . b i s s e l l . c o m
Tip:
Before cleaning under low furniture, check
area first for objects that might harm the unit
or block the vacuum hose.
1. 2.
3.
1.
2.
Release Button
ug110-4048_3920E_508.indd 7 ug110-4048_3920E_508.indd 7 5/7/08 3:56:56 PM 5/7/08 3:56:56 PM