Briggs & Stratton 1695354 - Manual (Page 8)

6
Assembly
Remove Blowout Baffle
1.Remove and discard short blowout baffle (C, Figure
4), carriage bolts (B) and locknuts (D) from mower
deck (A).
Figure 4. Baffle Removal
A. Mower Deck
B. Carriage Bolts,5/16-18 x 3/4
C. Blowout Baffle, Short
D. Nuts, Whizlock, 5/16-18 x 3/4
C
A
D
D
B
Install Baffles
1. Determine which baffle to use. See Figure 5
Chart.
2. Lift side discharge chute (H, Figure 6).
3. Insert baffle (F) through discharge opening and
position baffle into place.
4. Tighten carriage bolts (A) and nuts (E) on baffle
(F).
5. Tighten carriage bolt (B) and nut (E) on baffle (F).
6. Position baffle (G) into place.
7. Tighten carriage bolts (C) and nuts (E) on baffle
(G).
8. Tighten carriage bolts (D) and nuts (E) on baffle
(G).
“A”
44” Mower Deck 50” Mower Deck
“A” RH side 26-1/4” long RH side 29-3/4” long
“B” LH side 24-7/8” long LH side 27-3/4” long
“B”
Figure 5. Baffle Chart