Philips Centrale vapeur haute pression - Manual (Page 13)

Problem Cause Solution
Steam escapes
from the filling
hole area during
ironing.
You may not have tightened the steam
tank cap properly or you have spilled
some water round the filling hole.
Switch off the appliance and let
it cool down. Remove the steam
tank cap, wipe away the water
round the filling hole and tighten
the steam tank cap again. Then
switch the appliance back on.
Wet spots
appear on the
garment during
ironing.
The wet spots that appear on your
garment after you have steam ironed for
some time may be caused by steam that
has condensed onto the ironing board.
Iron the wet spots without steam for
some time to dry them. If the underside
of the ironing board is wet, wipe it with a
piece of dry cloth.
To prevent steam from
condensing onto the ironing
board, use an ironing board with
a wire mesh top.
EnGlish 1