Bissell 90Y5 - Manual (Page 8)

w w w . b i s s e l l . c o m
O
perations
8
Cleaning hard floors continued
2. To sanitize an area of your floor, (attack
invisible germs and bacteria) place the
center of the Healthy Home Steam Mop Max
over the spot for a minimum 15 seconds, but
no longer than 20 seconds. For larger areas,
overlap swivel head placement.
3. When the Healthy Home Steam Mop Max
stops emitting steam, simply remove the
water tank, refill, and continue cleaning.
Carpet Refresher Attachment
This accessory is recommended for the
refreshing of carpets. Once the Healthy
Home Steam Mop Max is cradled in the
carpet refresher attachment, it will easily
glide over the carpet.
NOTE: Always be sure a mop pad is in
place before placing in carpet refresher
attachment. Only white mop pads
should be used with the carpet
attachment. Do not use carpet
attachment on spots or stains, or glide it
over the same spot for longer than 20
seconds.
1. Attach the mop pad to the swivel mop head.
As directed in step 1 on page 6.
2. Place the swivel mop head, with mop pad
attached, in the carpet refresher attachment.
Note: that the Healthy Home Steam Mop
Max rests in the carpet refresher
attachment and may not stay attached
to the swivel mop head. It is meant to
glide over the carpet.
3. Fill the water tank with water. Begin
refreshing your carpet or rug by pushing the
Healthy Home Steam Mop Max in a forward
and backward motion, releasing steam as
you go.
4. When you have finished refreshing your
carpet or rug, unplug the Healthy Home
Steam Mop Max and remove from the
carpet or rug.
NOTE: Move the Healthy Home Steam
Mop Max and carpet refresher
attachment in a continuous motion until
you are finished. This product is not
intended to be used as a carpet cleaner,
only a carpet refresher or deodorizer.
Never attempt to use the Healthy Home
Steam Mop Max on carpet without the
carpet refresher attachment in place.
DO NOT leave the mop in a stationary
position.
Tip:
During first use, it may
take several seconds for
the Steam Mop to begin
steaming. The water
needs to flow through
the filter to the heater.
This delay will only occur
during initial use or when
using a
new filter.
2
3