B&K AVR101 Series 100 - Manual (Page 47)

Control Out 2, 3, and 4 - Control out 2, 3, and 4 can be used in either zone. For each source they can be
programmed to be on when that source is selected in zone 1, zone 2, or both zones. If the source is selected in
neither zone the control out will be off. Control outs 2, 3, and 4 can also be set to REMOTE. In REMOTE mode
your receiver acts like a remote repeater - IR remote signals detected by your receiver are repeated on the control
out. REMOTE mode is a global override for all sources.
'9' & =21( 
CONTROL OUT SETUP for DVD
move to new line
previous page
↑ ↓
M E N U
2 Control Out 2 Zone 2
adjust parameter
←→
A U D to select control
1 Control Out 1 Phones
3 Control Out 3 Z1+Z2
4 Control Out 4 Remote
Using AV system controller
select a source to setup
return to normal operation MENU MENU 10
return to MAIN MENU MENU MENU 9
return to SETUP MENUS MENU MENU 8
return to ADVANCED SYSTEM SETUP MENU MENU 7
set control out 3 and 4 repeat 1 - 5 repeat 1 - 5 6
set control out 2 for other sources repeat 2 - 4 repeat 2 - 4 5
set desired control out VOLUME KNOB
ˆ
(REW) or
‡
(FF) 4
return control to receiver AUDIO 3
select source for Control Out setup
U
(SOURCE) step to source desired source 2
move to Control Out 2 ∧
(UP) or
∨
(DOWN)
­
(PAUSE) or
V
(STOP) 1
Action From Front Panel From Remote
FACTORY RESET
Should you ever need to completely reset the receiver to the original factory settings from the front panel press the
SLEEP, DOWN, and LEVEL buttons simultaneously. The receiver will perform a complete reset and erase all
user programmed presets and menus.
45 p/n 12699 Rev. 9808B