B&K AVR101 Series 100 - Manual (Page 49)

RECEIVER SPECIFICATIONS
5 years receiver
1 year remote Warranty:
See Warranty page for
complete explanation
55 pounds Weight: 95 dB S / N (A-weighted):
17"(w)x17"(d)x6.25"(h) Dimensions: 1.4 dB Dynamic headroom:
Rails - 4 Amp/250 Volt (slow blow type) 14 V/
µ
sec Slew rate:
Line -12 Amp/250 Volt Replacement fuses: 28 Amps Current (peak to peak):
31 watts standby 150 Damping factor:
( 9 amps @ 120 V) 0.09 % @ 1 kHz THD (S + N):
1080 watts max Power consumption: 5 Hz - 45 kHz Frequency response:
120/220/240 VAC Line voltage: 105 watts @ 1 kHz Power rating: 8 ohms:
Miscellaneous Amplifier Specifications
300 Ohms Antenna Input Impedance: 75 Ohms Antenna Input Impedance:
70 dB, A Weighted Signal to Noise Ratio:
30 dB Selectivity: 65 dB Alternate Channel Selectivity:
28 dBf Sensitivity: 15 / 35 dBf Mono/Stereo Sensitivity:
12 dBf IHF (Usable) Sensitivity:
2 dB Capture Ratio:
28 dBf Sensitivity: 20 Hz - 15 kHz, +1/ -3 dB Frequency Response
Less than 0.3% Total Harmonic Distortion: Less than 0.25% Total Harmonic Distortion:
520 - 1620 kHz Frequency Range: 87.5 - 107.9 MHz Frequency Range:
AM section Tuner Specifications FM Section Tuner Specifications
1/1 Digital Outputs coax/optical
7/ 5 Digital Inputs coax/optical
5 Video Outputs 5 Audio Analog Outputs
7 Video Inputs 7 Audio Analog Inputs
8 Surround Outputs
-12.5 dB Noise Test Reference Level:
75 Ohms Output Impedance: 221 Ohms Output Impedance:
75 Ohms Input Impedance: 50 k Ohms Input Impedance:
89 dB CCIR 2 k Weighted
max level Signal to Noise Ratio:
2 V P-P Maximum Output Level: 9 V rms Maximum Output Level:
2 V P-P Maximum Input Level: 63 mV Input Sensitivity:
20 Hz - 10 MHz
±
3dB Frequency Response:
5 Hz - 20 kHz ,
+0/−
0.5dB
Frequency Response:
Video Specifications Audio Specifications
Specifications subject to change without notice
47 p/n 12699 Rev. 9808B