Brother PE 150 User Manual
Page 73
70
Linking two or more embroidered patterns (using the 90˚ rotation feature)
Example: Patterns in Flower card
(No. 2)
1. Check the lengths of the patterns you wish to
embroider continuously by touching
“LAYOUT”. If the length is within 18.2 cm (7-
3/16”), you can proceed with embroidering
just by changing the embroidery location,
without having to re-set the fabric in the
frame.
1
Finished appearance
2
Within 18.2 cm (7-3/16”)
After selecting the pattern, touch “LAYOUT” to
check the size of the pattern.
The size of the pattern is displayed on the left
side on the screen.
2. Draw a line on the fabric marking the place
where the patterns will be embroidered. Find
the center line, and then draw the line along
the whole length of the pattern, marking it off
into two even lengths. Mark the embroidery
start position with a cross by drawing another
line across this line.
1
Embroidery start position
ABC
3. Align the line on the fabric with a line on the
embroidery sheet, and fit the fabric and
embroidery sheet into the frame. Clamp the
frame with the carriage at the place indicated
by “a”. (see next page)
4. After touching “LAYOUT”, touch “90˚
clockwise” to change the arrow in the display
so that it points to the right. Then touch
“START/CENTER” to set the current needle
position as the embroidery start position.