Bissell 3512 - Manual (Page 14)

10
Replace Drive Belt
Unplug unit from electrical outlet.
With Rotating Floor Brush removed (steps 1-5 above)from
vacuum cleaner, stretch old belt to clear Motor Pulley, and
remove belt. Discard.
Place new Drive Belt over Motor Pulley and stretch other end
over crown of Rotating Floor Brush.
Place belt end of Rotating Floor Brush into its slot and hold it
in place with your left hand, while slowly pulling opposite end
of brush down into its slots with your right hand
Turn Rotating Floor Brush by hand several times in direction
of Motor Pulley. If properly installed, Drive Belt will center itself
on Rotating Brush crown.
Position Brush Cover Tabs in the four Brush Cover slots along
front of Powerfoot, and snap Brush Cover into place.
1.
2.
Replacement Belts
Use only BISSELL ® Replacement Belt Style 2 (#32015) in your
Upright Vacuum Cleaner.
3.
3
4
4.
5.
6
Tip:
This is a good
time to clean
the Slide Track
area of hair,
string, dirt,
or other
obstructions.
Grasp Rotating Floor Brush at both ends and lift up. Clean
strings, hair and other debris from Rotating Floor Brush,
paying particular attention to brush ends.
Clean strings, hair and other debris from Motor Pulley and
Drive Belt areas. Inspect entire Drive Belt carefully for wear,
cuts or stressed areas.
Check Air Passageway for obstructions. Remove debris from
this area.
Reassemble unit (see steps 4-6 below).
4.
5.
6.
7.
6.