Blaupunkt FRANKFURT RCM 169 - Manual (Page 46)

95
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
CLK (Clock)
Use this menu to adjust the clock settings.
SET
The time is set automatically when the au-
dio system is tuned into an RDS station with
the “CT” (clocktime) function.
If this signal is not available, it is possible to
adjust the clock with “SET”.
The time will flash in the top line of the dis-
play in 12 (a.m./p.m.) or 24-hour mode.
Use << />> to select the value you want to
adjust (hours/minutes), use / to adjust
the value.
SYNC
The time is synchronised automatically with
the RDS-CT signal.
This synchronisation function can be
switched off when you want to display a dif-
ferent time or when the RDS-CT and DCF-
77 time signals (atomic clock) are not strong
enough.
Use the rocker switch / to select the type
of synchronisation:
- RDS Sync
- DCF Sync
- AutoSync
- Sync off
Use << on the rocker switch to switch syn-
chronisation off (“Sync off”). Use >> to re-
turn to the previous mode.
RDS Sync
The clock is synchronised with the RDS-CT
signal only.
DCF Sync
The clock is synchronised with the DCF-77
signal only. When you switch off the audio
system (by pressing ON for approx. 1 sec.),
the system will not switch off immediately in
order to synchronise the time first. While this
process is taking place, you will hear “Big
Ben”. After the synchronisation has been
completed, the system will switch off after a
couple of minutes. If the DCF-77 signal is
not available, the system will switch off af-
ter a few seconds.
AutoSync
The clock is synchronised with the RDS-CT
signal or the DCF-77 signal. The system will
not attempt to receive the DCF-77 signal
unless the time cannot be synchronised with
the RDS-CT signal.
Sync off
The internal clock will not be synchronised.
MODE
Select the clock display.
(12h mode << />> 24h mode).
If you select the 12h mode, a.m. will appear
to indicate the morning hours and p.m. for
the afternoon/evening.
VIEW (Displaying the time)
There are a number of different display
modes, depending on how the audio sys-
tem has been connected.
a) the audio system can be switched off
with the ignition.
The system is switched off with “ON” when
the ignition is switched on.
DSC programming