Bissell ZING 22Q3 - Manual (Page 7)

Bag change indicator
The bag change indicator is located
below the swivel hose. If the bag
change indicator turns orange while
you are vacuuming, the dust bag
needs to be replaced. The dust bag
may appear to be full or only par-
tially full depending upon the type of
debris picked up. Fine particles can
block the airflow in the dust bag and
reduce suction before the dust bag
is full. If the bag change indicator
remains orange, even after changing
the dust bag, turn the vacuum off and
check for a clog in the hose or tools.
Dust bag replacement
1. Turn the power OFF ( ). Unplug the
vacuum from electrical outlet.
2. Disconnect hose
3. Open the dust bag compartment by lift-
ing up on the latch on the door on the
front of the vacuum.
4. Lift out the dust bag holder and dust bag.
5. Release the dust bag from the holder by
pressing the dust bag holder clip and
pulling the dust bag out of the holder.
Discard the used dust bag.
6. Slide the new dust bag into the holder
by inserting the dust bag into the tabs
located at the bottom of the holder.
Then press the dust bag holder clip,
insert the dust bag and release the dust
bag holder clip to hold the dust bag in
place.
7. Place holder and new dust bag back
into the dust bag compartment, making
sure the entire bag is tucked in below
the seal gasket.
8. Close dust bag compartment door and
press down gently until it locks into
place.
NOTE: The dust bag compartment
door will not close without the
dust bag in place.
9. Reconnect hose.
w w w . b i s s e l l . c a 1 - 8 0 0 - 2 6 3 - 2 5 3 5
7
O
perations
3.
4.
5.
WARNING:
To reduce the risk of electric shock,
turn power switch OFF and dis-
connect plug from electrical outlet
before performing maintenance or
troubleshooting checks.
Bag Change
Indicator