Belkin F1DZ104T User Manual
Page 8
1. Boot the computer you wish to connect via USB as you would normally
with the keyboard, monitor, and mouse connected directly
to the computer.
2.
After the operating system finishes loading, connect the Switch to the
USB computer using the USB A-to-B part of your USB KVM cable*. Your
computer should recognize your Switch and automatically install the HID
USB driver. Once the driver is installed, you can power down your
computer and prepare to connect it to the Switch.
3.
Plug in the male VGA connector of a KVM cable to the VGA port on the
computer. Connect the other end (the female connector) of the VGA cable
to the back of the Switch for the appropriate port.
4. Connect the USB cable’s A-type connector to an available USB port on
your USB computer. Connect the other end of the USB cable
(with the B-type connector) to the corresponding port on the back
of the Switch.
Repeat steps 1 through 4 for each additional USB computer you wish
to connect.
Power on all connected computers. The Switch is now ready for use.
*Please refer to the first page for part numbers.
Connecting Computers to the Switch
(Video and USB Connection)
4
VGA
VGA
VGA
VGA
VGA
USB
USB
USB
USB
04
04
04
03
03
03
02
02
02
01
01
01
P74183ea_F1DZ102-104_QIG.qxd 16-04-2003 10:02 Page 6