Liebherr KP 4220 Comfort - Manual (Page 6)

u Align the appliance so that it
stands firmly and on a level by
applying the accompanying
spanner to the adjustable-
height feet (A) and using a
spirit level.
u Then support the door: Extend
the adjustable foot at the turn
hinge (B) until it rests on the
floor and then make a further
90° turn.
When a Side-by-Side appliance (S…) is fitted together with
a second appliance (as a SBS combination):
u Proceed according to the Side-by-Side combined fridge-
freezer installation instructions. (Accessories bag of the SBS
freezer/appliance with freezer compartment)
Note
u Clean the appliance (see 6.2) .
If the appliance is installed in a very damp environment,
condensate may form on the outside of the appliance.
u Always see to good ventilation at the installation site.
4.3 Changing over the door hinges
You can change over the door hinges if necessary.
NOTICE
Risk of damage to side-by-side appliances due to condensa-
tion!
When a side-by-side appliance (S…) is fitted together with a
second appliance (as a SBS combination), the door hinges
must remain as delivered.
u Do not change over the door hinges.
Ensure that the following tools are to hand:
q
Torx® 25
q Torx® 15
q Screwdriver
q Battery-powered screwdriver, if necessary
q
Second person for fitting work, if needed
4.3.1 Detaching the door
Note
u Remove any food from the door racks before removing the
door, so that no food falls out.
Fig. 4
u Close the door.
u Pull off the cover Fig. 4 (10) forwards and upwards.
u Lift off the cover Fig. 4 (11) .
CAUTION
Risk of injury if the door tips!
u Take good hold of the door.
u Set down the door carefully.
u Unscrew the upper turn hinge Fig. 4 (12) (2x Torx® 25)
Fig. 4 (13) and lift it off.
u Lift off the door and set it aside.
4.3.2 Changing the bearing parts
Fig. 5
u Lift out the bearing pin Fig. 5 (22) together with washer
Fig. 5 (23) and adjustable-height foot Fig. 5 (24) .
u Lift off the stopper Fig. 5 (21) .
u Unscrew Fig. 5 (26) the turn hinge Fig. 5 (25) .
u Unscrew Fig. 5 (29) the bearing element Fig. 5 (28) , transfer
it to the opposite location hole of the turn hinge and screw it
firmly into place.
u Carefully lift off the cover on the handle side Fig. 5 (27) and
transfer it to the opposite side.
u Screw the turn hinge Fig. 5 (25) firmly into place on the new
hinge side, possibly using a cordless screwdriver (with
4 Nm).
u Re-insert the stopper Fig. 5 (21) into the other hole.
u Re-insert the bearing pin Fig. 5 (22) together with the
washer and adjustable-height foot. In so doing, pay attention
that the locating lug points backwards
4.3.3 Transferring the handle
u Transfer the spring clamp
Fig. 6 (31) : Depress the
latch nose and pull the
spring clamp off over it.
u Slide the spring clamp
into place on the new
hinge side until it clicks
into place.
Fig. 6
Putting into operation
6 * Depending on model and options