Liebherr KBes 4260 Premium BioFresh - Manual (Page 9)

w The display indicates c .
w The menu symbol Fig. 3 (5) shines.
u Using the Up setting button Fig. 3 (7) and Down setting
button Fig. 3 (6) , select h .
u To confirm: briefly press the SuperCool button Fig. 3 (2) .
u To set the display brighter: press the Up
setting button Fig. 3 (7) .
u To set the display darker: press the Down
setting button Fig. 3 (6) .
u To confirm: briefly press the SuperCool
button Fig. 3 (2) .
w The brightness is adjusted to the new value.
u To deactivate the setting mode: press the On/Off button
Fig. 3 (3) .
-or-
u Wait for 5 minutes.
w The temperature is indicated again in the temperature
display.
5.2 Child proofing
The child-proofing function enables you to make
sure that the appliance is not inadvertently switched
off by playing children.
5.2.1 Setting the child lock function
u To activate the setting mode: press SuperCool button
Fig. 3 (2) for about 5 s.
w The display indicates c .
w The menu symbol Fig. 3 (5) shines.
u Briefly press theSuperCool button Fig. 3 (2) to confirm.
When c1 is indicated in the display:
u to activate the child lock, briefly press the
SuperCool button Fig. 3 (2) .
w The child lock symbol Fig. 3 (12) shines. c flashes in the
display.
When
c0 is indicated in the display:
u to deactivate the child lock, briefly press the SuperCool
button Fig. 3 (2) .
w The child lock symbol Fig. 3 (12) goes out. c flashes in the
display.
u To deactivate the set-up mode: press On/Off button
Fig. 3 (3) .
-or-
u Wait for 5 minutes.
w The temperature is indicated again in the temperature
display.
5.3 Door alarm
If the door is open for longer than 60 seconds, the
audible warning will sound.
The audible alarm is automatically silenced when
the door is closed.
5.3.1 Muting the door alarm
The audible alarm can be muted when the door is open. The
sound switch-off function is active as long as the door is left
open.
u Press alarm button Fig. 3 (1) .
5.4 Refrigerator compartment
The natural circulation of air in the refrigerator compartment
results in zones differing in temperature. It is coldest directly
above the plate separating off the BioFresh zone and at the
rear wall. It is warmest at the top front of the compartment and
in the door.
5.4.1 Food refrigeration
Note
The energy consumption increases and the cooling perform-
ance decreases if the ventilation is inadequate.
u Always keep the air slits of the fan free.
u Place butter and preserves in the upper area and in the door
(see Appliance at a glance).
u Use recyclable plastic, metal, aluminium and glass
containers and cling film for wrapping.
For appliances from 1216 mm high:*
u Use the front area of the refrigerator compartment floor only
for briefly putting down cooled products, e.g. when rear-
ranging and sorting. However do not leave cooled products
there otherwise they may be pushed back or tipped over
when the door is closed.
u Do not store food too close together to enable good air
circulation.
u To safeguard bottles from tipping over: move the bottle
holder.
At the base of the refrigerator compartment, the integrated
bottle shelf or alternatively the glass shelf can be used:
u To use the bottle shelf: store
the glass shelf compactly
under the bottle shelf.
u Place the bottles with the
base pointing backwards
facing the rear wall.
If the bottles project beyond
the bottle shelf:
u set the lower door rack one
position higher.
5.4.2 Setting the temperature
The temperature depends on the following factors:
- the frequency of opening the door
- the room temperature of the installation location
- the type, temperature and quantity of the food
The temperature can be set from 9 °C to 3 °C, the recom-
mended temperature is 5 °C.
u For a higher temperature setting: press Up button Fig. 3 (7) .
u For a lower temperature setting: press Down button
Fig. 3 (6) .
w When the button is pressed the first time, the previously set
value is indicated, flashing, in the temperature display.
u To change the temperature in 1 °C steps: briefly press the
button.
u To change the temperature continuously: hold down the
button.
w The value is displayed flashing during the setting operation.
w The actual temperature is displayed about 5 s after the last
press of a button. The temperature slowly adjusts to the new
value.
5.4.3 SuperCool
With SuperCool you switch to the highest cooling
performance to reach lower cooling temperatures.
Use SuperCool, to rapidly cool large amounts of
food.
The SuperCool function uses slightly more energy.
Control
* Depending on model and options 9