Liebherr CTNes 4753 Premium NoFrost - Manual (Page 4)

12
Operating and control elements
Freezer
5
Temperature display
6
Temperature setting button
7
SuperFrost button
8
Audible warning on/off button
9
On/Off button
Refrigerator
1
On/Off button
2
Fan button
3
Temperature setting button
4
Temperature display
Setting the temperature
The temperature of the refrigerator and freezer compartment can
be set separately.
Setting the refrigerator temperature:
Press the Up/Down button
3
, the LED in
the temperature display
4
for the next
lower temperature value will light up.
Keep pressing the Up/Down button
3
until the desired value is displayed.
Setting the freezer temperature:
Press the Up/Down button
6
until the desired value is displayed
in the temperature display
5
.
Note
After a certain period of operation, the interior temperature will
adjust to the value which has been set.
1 2 3
4
9 7
5
6 8
Switching the appliance on and off
Clean the interior of the appliance before switching it on for the
first time (see "Cleaning").
To switch on
Press the On/Off button
1
or
9
so that the temperature displays
light up.
To switch the refrigerator compartment off
Press the On/Off button
1
for approx. two seconds.
Note: If the freezer compartment (On/Off button
9
) is switched
off, the entire appliance will be switched off.
Dimensions (mm)
Setting up
• Do not place the appliance in areas of direct sunlight or next to a
cooker, radiator or similar object.
• The floor on which the appliance stands should be horizontal and
level. To compensate for any unevenness, adjust the height of the
feet with the open-ended spanner supplied.
•
Do not cover ventilation openings
or grille.
• Do not place heat-emitting appliances, e.g.
microwave oven, toaster, etc., on top of the
appliance.
• Standard EN 378 specifies that the room in
which you install your appliance must have a
volume of 1 m 3 per 8 g of R 600a refrigerant
used in the appliance, so as to avoid the forma-
tion of inflammable gas/air mixtures in the room
where the appliance is located in the event of
a leak in the refrigerant circuit. The quantity of
refrigerant used in your appliance is indicated
on the type plate on the inside of the appliance.
Electrical connection
Only operate the appliance with alternating current (AC).
The permissible voltage and frequency are indicated on the type
plate. The position of the type plate is shown in the section entitled
Description of the appliance.
The socket must be properly earthed and protected by a fuse.
The tripping current of the fuse must be between 10 A and 16 A.
The socket must not be situated behind the appli-
ance and must be easily accessible.
Do not connect the appliance using an exten-
sion cable or extension socket.
Do not use stand-alone inverters (conversion
of direct current to alternating current/three-
phase current) or energy-saving plugs. Risk
of damage to the electronic control system!