Performance checkllst, Final preparation – Bertazzoni X244GGVX User Manual

Page 10

Advertising
background image

10

3. Flexible Connections:

a) If the unit is to be installed with flexible couplings and/or quick disconnect fittings, the installer must use a

heavy-duty, AGA design-certified commerciai flexible connector of at least 1/2" (1.3 cm) ID NPT (with

suitable strain reliefs) in compliance with ANSI Z21.41 and Z21.69 standards.

b)

In Canada: CAN 1-6.10-88 metal connectors for gas appliances and CAN 1-6.9 M79 quick disconnect

device for use with gas fuel.

CAUTlON: Leak testing of the appliance shall be conducted according to the manufacturer's instructions. Before placing
the oven into operation, always check for leaks with a soapy water solution or other acceptable method. DO NOT USE
AN

OPEN

FLAME TO CHECK FOR LEAKS!

A properly-grounded horizontally- mounted electrical receptacle should be installed no higher than 3" (7.6 cm) above the
floor, no less than

2”( 5 cm)

and no more than

8”(20,3 cm)

from the right side (facing product). Check all local code

requirements.

An agency-approved, properly-sized manual shut-off valve should be installed no higher than 3" (7.6 cm) above the floor
and no less than

2”( 5 cm)

and no more than

8”(20,3 cm)

from the left side (facing product). To connect gas between

shut-off valve and regulator, use agency-approved, properly sized flexible or rigid pipe. Check all local code
requirements.

PERFORMANCE CHECKLlST

All burners are tested before leaving the factory. There are no adjustments for the burners if connected according to the
information on the rating plate. Check each burner for proper operations. Flames should be blue in all settings. If service
is required, contact your dealer for the name of their authorized service agency. Gas conversions and initial installation
are not the responsibility of the manufacturer.
The installer should carry out the following performance checks. Refer to instructions below.

1. Check surface burner ignition.
2. Check air shutter adjustment (only for oven and broiler burner)- sharp blue flame, no yellow tipping, sooting or flame
lifting
3. Check low flame adjustment
4. Check broiler and oven ignition - all burner ports.
5. Check for gas leaks (odors) at all gas connections.
6. Check oven bake and convection bake function.

FINAL PREPARATION

1. Some stainless steel parts may have a plastic protective wrap which must be removed. The interior of the oven

should be washed thoroughly with hot soapy water to remove film residues and any installation dust or debris
before using it for food preparation, then rinsed and wiped dry. Solutions stronger than soap and water are rarely
needed.

2. All stainless steel body parts should be wiped with hot, soapy water and with a liquid cleaner recommended for

use with stainless steel If buildup occurs, do not use steel wool, abrasive cloths, cleaners, or powders! If it is
necessary to scrape stainless steel to remove encrusted materials, soak with hot, wet cloths to loosen the
material, then use a wood or nylon scraper. Do not use a metal knife, spatula, or any other metal tool to scrape
stainless steel! Scratches are almost impossible to remove.

NOTE: These installation instructions should remain with the unit for future reference. The electrical diagram is located in
the backside or the appliance.

A 2”( 5 cm)

B 3”(7,6

cm)

D 8”(20,3

cm)

Advertising