Brocade BigIron RX Series Hardware Reference Manual - Manual (Page 172)

160 Brocade BigIron RX Series Hardware Installation Guide
53-1002483-03
Port specifications
7
Electromagnetic approvals
• FCC Part 15, Subpart B (Class A)
• EN 55022 (CE mark) (Class A)
• EN55024 (CE mark) (Immunity) for Information Technology Equipment
• ICES-003 Emission Certification (Interference Causing Equipment Standard) (Canada) (Class
A)
• AS/NZ 55022 (Australia) (Class A)
• VCCI (Japan) (Class A)
• EN 61000-3-2
• EN 61000-3-3
• EN 61000-6-1
Port specifications
This section provides pin assignments for the following ports:
• Management module’s Console port (serial connector)
• Management module’s management port (RJ-45 unshielded twisted pair (UTP) connector)
Console port pin assignments
The Console port is a standard male DB-9 connector, as shown in Figure 50 . For information about
how you can use this port, refer to “Console port” on page 8.
FIGURE 50 Console port pin and signalling details
Most PC serial ports require a cable with a female DB-9 connector. However, terminal connections
will vary, requiring a cable with either a DB-9 or DB-25 connector, male or female.
Serial cable options between the BigIron RX Series chassis and a PC or terminal are shown in
Figure 51 .
Pin Assignment
DB-9 male
Pin Number Switch Signal
6
1 Reserved
2 TXD
(output)
3 RXD (input)
4 Reserved
5 GND
6 Reserved
7 Reserved
8 Reserved
9 Reserved
1 5
9