Brinkmann Grill King DeLuxe Heavy-Duty Outdoor Charcoal Grill & Smoker - Manual (Page 6)

5
Step 5
With the help of a friend, set the unit
upright. Try to minimize stress on the legs
of the grill.
Step 6
Insert wire wood rack (curved ends
pointed down) into holes on bracket near
bottom of legs then tighten all bolts until
secure.
Step 7
Attach hood stops to the outside back of
the body using M6 x 12 bolts. Thread
bolts into welded nuts and tighten until
secure.
Step 8
Attach the hinges (with the spine side out)
to the outside back of the body using
M6 x 12 bolts. Thread bolts into welded
nuts but do not tighten at this point. Place
lid over the body and attach hinges to the
outside back of the lid using M6 x 12
bolts. Thread bolts into welded nuts.
Tighten all hinge bolts on lid and body
until secure.
Step 9
Attach handle to the lid using two M5 x 75
bolts, flat washers, spacers, spring
washers and M5 x 4 hex nuts. The heads
of the bolts should be slightly recessed
into the wooden handle when fully
tightened.
Hood
Stop
Hood
Hinge
M5 x 75
bolts
curved end
pointed down
M6 X 12
bolts
Flat
washer
Spacer
Spring
washer
M5 X 4
hex nut