Philips SHAVER Series 9000 Nass- und Trockenrasierer - Manual (Page 25)

1 Hold the shaver upside down above the holder.
Make sure the front of the shaver points
towards the SmartClean system.
2 Place the shaver in the holder (1), tilt the
shaver backwards (2) and press down the top
cap to connect the shaver (‘click’) (3).
, The battery symbol and the on/off button
start to flash, which indicates that the shaver is
charging.
3 Press the on/off button on the SmartClean
system to start the cleaning program.
, The on/off button and the rinsing symbol both
light up continuously.
Note: The rinsing phase takes approx. 10 minutes.
, During the drying phase, the drying symbol lights
up continuously.
Note: The drying phase takes approx. 4 hours.
, When the cleaning program has been completed,
the ready symbol lights up continuously.
, The battery symbol lights up continuously to
indicate that the shaver is fully charged.
Note: Charging takes approx. 1 hour.
ENGLISH 25