Bose Cinemate Digital Home Theater Speaker System - Manual (Page 21)

O
PERATION
21
2SHUDWLRQIP 
O PERATION
English Français Español
Verifying a device code
When you programmed your remote during setup, a device code for each source was stored
in the remote. If you need to verify which code has been programmed for a particular source,
follow the steps below.
If you need to reprogram a device code, see “Setting up the remote to control other sources”
on page 14.
1. Press and hold Setup until all five source buttons light up (about three seconds).
2. Press the source button of the device you want to verify (TV, CBL-SAT, DVD, VCR, or
AUX). Only the selected source button will remain lit.
3. Press Info.
4. Press 1 on the remote and count the number of times the five source buttons blink
(zero is indicated by a long blink). This is the first digit.
5. Press 2 on the remote and count the number of times the five source buttons blink
(zero is indicated by a long blink). This is the second digit.
6. Press 3 on the remote and count the number of times the five source buttons blink
(zero is indicated by a long blink). This is the third digit.
7. Press 4 on the remote and count the number of times the five source buttons blink
(zero is indicated by a long blink). This is the fourth digit.
8. Press 5 on the remote and count the number of times the five source buttons blink
(zero is indicated by a long blink). This is the fifth digit.
9. Press Exit.