Philips PhotoViewer - Manual (Page 5)

7
2.5 How to read this manual
2.5.1 Icons
Caution
Describes the actions required to avoid
dangerous or illegal situations.
Note
Additional information.
Tip
Information that is useful to know but not
essential to the task. For example, information
about alternative use.
3 Getting started
In this chapter, the basic steps to get you started
are described.
3.1 Prepare
1 Remove the protective foil from the bottom
of the remote control. 1
1
3.2 Connect
3.2.1 The video cable to a TV
The PhotoViewer has three video outputs:
•
Composite video for standard defi nition TVs
(yellow connector).
• Component video for high-defi nition TVs
(red, green and blue connectors).
• S-Video for standard defi nition TVs (cable
not included).
Note
See the documentation that came with your
TV for information about the video inputs
on your TV. Check the connectors on your
TV to determine whether you need the
composite video cable (yellow connector) or
the component video cable (red, green and blue
connectors). The connectors have the same
color as the plugs on the cables.
To connect the video cable to a TV:
Caution
Switch off the TV and disconnect it from the
power outlet.
1 Connect the correct by-packed video cable
to the video output on the PhotoViewer.
2 Connect the other end of the video cable to
your TV. 2 3
2
3
3.2.2 The audio cable to a TV or audio
system
The PhotoViewer has one audio ouput:
•
Left and right audio signal (red and white
connectors).
ENGLISH
01_Picture viewer SPV3000_0807_E7 7 01_Picture viewer SPV3000_0807_E7 7 8/7/07 2:47:37 PM 8/7/07 2:47:37 PM