Recording, Maintenence and care – Hyundai H-1006 User Manual

Page 5

Advertising
background image

5

NOTE:
· Press the PAUSE button to pause the playing.

· Press the STOP/EJECT button to stop the playing, press the button again to open the cassette door and you can take out the tape.

· When the tape plays to the end, playing will be stopped automatically.

RECORDING

RECORDING FROM RADIO

· Slide the Function switch to RADIO position.

· Tune to the desired station by turning the Tuning control regulator.

· Insert a blank cassette into cassette compartment with tape upwards.

· Press the PLAY button and RECORD button simultaneously to start recording.

· Press the STOP/EJECT button when finished.
NOTE:
You may want to monitor playback during recording. You can adjust the sound with the VOLUME control. This adjustment does not affect the
content of recording.

MAINTENENCE AND CARE

· Check your batteries regularly, old or discharged batteries should be replaced. If the unit is not going to be used for some time or is being

run exclusively on the alternative power, remove the batteries to avoid leakage and damage.

· Electronic products of this kind should never be subjected to moisture or extreme temperatures.

· If necessary, clean the unit with a piece of cloth dampened with water only (be sure the AC power cord is disconnected from the power

supply).

· The heads and capstan are in constant contact with the moving tape. Use a small cotton bud with alcohol or special tape head cleaner to

clean these parts. Never touch the heads with anything metallic.

ERASE PROTECTION

· To prevent accidental erasing of a cassette, simply break off the two plastic tabs located on the cassette tape s rear

side.

· When a cassette with removed plastic tabs is inserted, the recording button cannot be pressed.

· If a cassette is to be erased and re-recorded at a later stage, simply cover the holes on the cassette where the tabs

were removed, with a piece of strong adhesive tape.

Advertising