Philips Epilier-Set – Limited Edition - Manual (Page 13)

guarantee and service
If you need service or information or if you have a problem, please visit the Philips
website at www.philips.com/support or contact the Philips Consumer Care Centre
in your country. You find its phone number in the worldwide guarantee leaflet. If
there is no Consumer Care Centre in your country, go to your local Philips dealer.
troubleshooting
This chapter summarises the most common problems you could encounter with
the appliance. If you are unable to solve the problem with the information below,
contact the Consumer Care Centre in your country.
Problem Cause Solution
The epilator
does not work.
The rechargeable
battery is empty.
Charge the epilator for 60 minutes.
The overheat
protection has been
activated.
When the epilator suddenly stops working
and the charging light starts flashing red,
the overheat protection has been
activated. Let the epilator cool down. The
charging light stops flashing after 30
seconds. When the epilator has cooled
down, switch it on again. If the charging
light starts flashing again, the epilator has
not yes cooled down sufficiently.
The overload
protection is
activated because
something got
caught between the
rotating discs, or
because you pressed
the epilator too hard
onto your skin.
When the overload protection has been
activated, the charging light flashes red.
Turn the discs with your thumb until you
can easily remove the item that is
blocking the rotating discs. Then switch
on the epilator again. Do not press the
epilator too hard onto your skin.
The precision
epilator does
not work.
The disposable,
non-rechargeable
batteries are empty
or have been
inserted incorrectly.
Replace the batteries or insert them
correctly (see ‘Inserting the batteries’ in
chapter ‘Using the precision epilator’).
EnglisH 13