Step 5, Step 6 – Bowflex Ultimate 2 User Manual
Page 7
7
step
5
Parts:
• Rack base assembly from Step 4
• Right Curl Bar Hook (#2)
• Left Curl Bar Hook (#3)
• Bar Hook Brackets (#4)
• Washer Hooks (#7)
Hardware Qty
• 2 3/4" Bolts (#13)
8
• Washers (#15)
14
• Nuts (#14)
8
Tools:
• Allen wrench (7/32”)
• Wrench/Socket (9/16”) or
Open End Wrench
5-1 Install the Left Curl Bar Hook (#3) at the two top, outside bolt holes on the left Side Tube (#9) using the hard
-
ware shown in Figure 5. Make sure that the Curl Bar Hook curves inward, around the Side Tube, and the
hook points toward the Base Plate. Tighten hardware completely.
5-2 Install the Right Curl Bar Hook (#2) to the right Side Tube as described above.
5-3 At the two lowest bolt holes on each Side Tube upright, install a Bar Hook Bracket (#4) and Washer Hook
(#7) using the hardware shown in Figure 5. Make sure the Bar Hook Brackets are pointing the same direc-
tion as the Curl Bar Hooks. Tighten hardware completely.
Note: There is no washer where the Bolt (#13) is inserted through the Washer Hook.
step
6
Parts:
• Rack assembly from Step 5
• Towel Rack (#5)
• Washer Hooks (#7)
Hardware
Qty
• 2 3/4" Bolts (#13)
2
• Washers (#15)
2
• Nuts (#14)
2
Tools:
• Allen wrench (7/32”)
• Wrench/Socket (9/16”) or Open End Wrench
6-1 Attach the Towel Rack (#5) and one Washer
Hook (#7) to the outside of each Side Tube (#9) above the Bar Hook Brackets (#4) using as the hardware
shown in Figure 6. Make sure that the Towel Rack rod is toward the Base Plate.
Note: There is no washer where the Bolt (#13) is inserted through the Washer Hook.
6-2 Completely tighten all hardware from Steps 1, 2, 4 and 6. (Hint: use the open end wrench to tighten the Nuts
from Step 2 and 4-3.) Make sure the rack sits evenly on all four feet. You may need to loosen and retighten
the hardware to adjust the unit.
�
�
�
�
��
��
��
�
Figure 5
(Left Tube – Front View)
��
��
��
�
�
�
�
�
��
�
�
�� ��
�
Figure 6