Barnett Crossbows Penetrator 350 - Manual (Page 7)

Attaching Bow Assembly to Stock
• Place the cables (with cable slide installed. See Figure 4 on
previous page) under front edge of the flight track -- this should
cause the string to rest on top of the flight track. Push bow as-
sembly until it seats securely over the nose plug. See Figure 5.
• Turn bow over and engage prod by seating the bow assembly
onto stock.
• Place lock washer on bolt, then insert bolt through bushing.
See Figure 6.
• Insert bolt through bow assembly into stock and tighten with
supplied hex key until the lock washer has compressed. (DO
NOT OVERTIGHTEN)
7
Installing an Optional Scope or Red Dot Sight
• Position your scope by moving it forward or backward until
the proper eye relief is found. This is typically three to four
inches from your eye to the eyepiece when you are holding the
crossbow in a shooting position.
• Tighten the scope mounting side plates with caution.
IMPORTANT: Be sure to tighten windage/elevation caps and
scope mount rings before shooting your crossbow.
Fig. 5
Fig. 6