Brother HL 5370DW - Manual (Page 61)

Wireless configuration for Windows ® using the Brother automatic installer application (For HL-5370DW)
51
4
l To communicate with the un-configured wireless machine, temporarily change the wireless settings on
your computer to match the machine’s default settings shown on this screen. Check the box after you
confirm these settings, and then click Next.
Note
„ If a message to restart your computer appears after the wireless settings have been changed, restart
your computer and then go back to step d and continue with the install skipping steps k and l.
„ For Windows Vista
®
users:
You can temporarily change the wireless settings on your computer, following the steps below:
1) Click the button and then Control Panel.
2) Click Network and Internet and then the Network and Sharing Center icon.
3) Click Connect to a network.
4) You can see the SSID of the wireless printer in the list. Choose SETUP and click Connect.
5) Click Connect Anyway and then Close.
6) Click View status of Wireless Network Connection (SETUP).
7) Click Details.... and check the Network Connection Details. It may take a few minutes to change
from 0.0.0.0 to 169.254.x.x IP address to be shown on screen (where x.x. are numbers between 1
and 254).
„ For Windows
®
XP SP2 users:
You can temporarily change the wireless settings on your computer, following the steps below:
1) Click the Start button and then Control Panel.
2) Click the Network and Internet Connections icon.
3) Click the Network Connections icon.
4) Choose and right-click Wireless Network Connection. Click View Available Wireless Networks.
5) You can see the SSID of the wireless printer in the list. Choose SETUP and click Connect.
6) Check the Wireless Network Connection status. It may take a few minutes to change from 0.0.0.0
to 169.254.x.x IP address to be shown on screen (where x.x. are numbers between 1 and 254).