Brother HL 5370DW - Manual (Page 90)

Wireless Configuration for Macintosh using the Brother installer application (For HL-5370DW)
80
5
j Read the Important Notice to enable the wireless interface. Hold down the Go button for 10 seconds,
and then release the Go button when the printer prints a Network Configuration page. Check the box
after you confirm the wireless setting is enabled, and then click Next.
Note
To confirm the wireless setting is enabled, check the text to the right side of IEEE 802.11b/g in the Node
Type section on the Network Configuration page. Active means that the wireless setting is enabled and
Inactive means that the wireless setting is disabled. If the wireless setting is disabled, press the Go button
for 10 seconds again.