Philips SQB1131-17 - Manual

English
1 SQB1111 / SQB1131
1 What is in the box
Note
Make sure you have all these items in
•
the box. Contact your dealer for any
missing or damaged items.
Plastic wall anchor x 2
Screw mount x 2
Movable mount x 1
Fixing mount x 1
Fixing knob x 1
M5 mounting screw x 2
M6 mounting screw x 2
Long screw x 2
Note
Two types of mounting screws (M5 and •
M6) are supplied but only one type
is needed. Check the design of your
speaker holes fi rst.
Note
The items described are the quantity •
supplied per unit pack. For SQB1111
and SQB1131, 2 packs and 5 packs are
supplied in the package respectively.
Tools that are needed but not
included:
Drill
•
9/64” drill bit
•
Philips head screwdriver •
Hammer •
2 Assembly
instructions
1
Drill two holes in the wall. The
size of the holes need to be
slightly smaller than the plastic wall
anchors. The distance between
the two holes must be the same
distance as the two holes on the
fi xing mount.
2
Punch the plastic wall anchors into
the two holes on the wall.
3
Ensure that the two holes on the
fi xing mount point at the plastic
wall anchors.
4
Put the long screws through the
fi xing mount into the plastic wall
anchors.
There are two ways to assemble
the rest of your items. Check the
design of the speaker holes and
select a suitable way to fi x your
speaker.
For speakers with two holes at
the back:
5
Ensure that the two outside holes
of the movable mount point at the
speaker holes.
6
Put two M5 (or M6) mounting
screws through the two outside
holes of the movable mount into
the speaker.
7
Ensure the ends of the mounting
screws are fi xed tightly into the
speaker. Place the fi xing knob on
top. Adjust the movable mount
to the desired angle. Then tighten
the lock of the fi xing knob until it
stops.
Note
In the above case, the screw mount •
is not needed.
For speakers with one hole at
the back:
8
Ensure that the screw mount
points at the central hole of the
movable mount.
9
Put the M5 (or M6) mounting
screw through the central hole of
the movable mount into the screw
mount.
10
Ensure the head of the mount-
ing screw is fi xed tightly into the
speaker. Place the fi xing knob on
top. Adjust the movable mount
to the desire angle. Then tighten
the lock of the fi xing knob until it
stops.
A5_SQB1111_indesign_updatedDec12.indd 1 A5_SQB1111_indesign_updatedDec12.indd 1 2008-12-17 2:49:34 PM 2008-12-17 2:49:34 PM