Philips AZ1602-17 - Manual (Page 7)

AZ 1605 /17
page
7
POWER SUPPLY
7
For the set (optional)
Open the battery compartment of the set and insert 6 batteries,
type R20, UM1 or D-cells (preferably alkaline).
Remove batteries if they are flat or the set is not going to be used
for a longer period of time.
Batteries contain chemical substances, so they should be
disposed of properly.
1 Check whether the power supply as shown on the type plate
corresponds to your local power supply. If it does not, consult
your dealer or service organization.
The type plate is located
on the bottom side of the set.
2 If the set is equipped with a VOLTAGE selector X, set this
selector to the local power supply.
3 Connect the power cord to the AC MAINS inlet and the wall
outlet. This switches on the power supply. The power cord is
inside the battery compartment.
The battery AC power supply will be switched off when the set is
connected to the mains. To change over to battery supply,
withdraw the plug from the unit’s AC MAINS inlet.
To disconnect the set from the power supply completely, remove
the power plug from the wall outlet.
The set complies with the FCC-Rules, Part 15 and with 21 CFR 1040.10.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
X
AC power supply
Batteries
English
AZ1605/17 english 8/11/00 10:44 AM Page 7