Philips AJ3720-17B - Manual (Page 14)

TROUBLESHOOTING
PROBLEM
– POSSIBLE CAUSE
• REMEDY
No sound
– Volume not adjusted
• Adjust the volume
– Headphones are connected
• Disconnect the headphones
No reaction to any operation of the
controls
– Electrostatic discharge
• Disconnect the set from the power supply
and reconnect the set after 3 seconds
Occasional crackling sound during FM
broadcast
– Weak signal
• Extend pigtail antenna fully
Continuous crackling/hiss disturbance
during MW(AM) broadcast
– Electrical interference from TVs, computers,
fluorescent lamps, etc.
• Move set away from other electrical
equipment
The alarm does not function
– Alarm time not set
• Set the alarm time
– Alarm mode not selected
• see ‘SETTING THE ALARM’
– Weekend sleeper selected for Saturday and
Sunday
• Deactivate weekend sleeper
– Volume too low for alarm radio options
• Adjust the volume
ALARM
RADIO GENERAL
14
English If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service center.
WARNING: Under no circumstances should you try to repair the set yourself, as this
would invalidate the warranty.
The production plate is located on the bottom of the set.
XP AJ 3720/17.2 29-03-2001 10:47 Pagina 14