Philips DVDR150099 - Manual (Page 36)

English
36 OPERATION
Installation
Update/Re-install TV channels
After initial installation is complete, it is possible to
perform the installation procedure again. If, for example,
your cable company adds TV channels, you may wish to
update the channel screen.
Note:
All previously stored channels will be erased and replaced.
1 In the installation menu, select ’ Auto ch. programming’
with the w/v (down or up cursor) buttons, then
press OK.
‰ Automatic search and installation starts.
’
Searching for TV channels,’ the number of
channels found so far and ’ Please wait’ appear on
the TV screen.
‰ When Automatic search and installation is
complete, ’
Auto m.search complete - XXX
channels found’ appears on the TV screen.
2 Press SYSTEM MENU to return to the previous
menu.
Add and delete TV channels
You can add channels that were not installed
automatically due to poor reception or delete channels
that you find not interesting. To customize the list of
channels available:
1
In the installation menu, select ’ Add/delete
channels’ with the w/v (down or up cursor)
buttons, then press the u (right cursor).
‰ The channel screen appears, and the cursor is on
the first channel.
2 Press w (down cursor) as often as required to select
the channel to be changed.
3 Press t/u (left or right cursor).
‰ The selected channel toggles to
Add or Del.
4 Press OK to store your choice.
5 Repeat steps 2-4 as often as necessary to add or
delete all the channels you want.
6 Press SYSTEM MENU twice to return to the
previous menu.
VCR Plus+ ch
If you intend to use the VCR Plus+ programming system,
you need to manually assign channel numbers to Guide
channel numbers.
1 In the Installation menu select ‘ VCR Plus+ ch.’ using
the w/v (down or up cursor.) Then press u (right
cursor)
2 Select a VCR Plus+ Guide channel with w/v (down or
up cursor.)
3 Enter the correct channel number with t/u (left or
right cursor) or 0-9. Refer to a channel mapping list
in your newspaper or TV guide. Enter channel
numbers as a three-digit number. For example, to
enter channel seven, press 0,0,7 or, press 0,1,2 for
channel twelve.
4 Confirm your selection by pressing OK.
5 Press the SYSTEM MENU button twice to return
to the previous menu.
I n s t a l l a t i o n
V C R P l u s + c h .
T o e x i t p r e s s
S Y S T E M M E N U
0 0 3
0 0 4
0 0 5
0 0 6
0 0 7
0 0 8
V C R P l u s + c h . C h a n n e l
I n s t a l l a t i o n
A d d
/ d e l e t e c h a n n e l
T o e x i t p r e s s
S Y S T E M M E N U
1 2
1 4
1 5
1 7
1 8
2 1
2 3
2 4 A d d
D e l e t e
A d d
A d d
D e l e t e
A d d
A d d
D e l e t e
I n s t a l l a t i o n
T o e x i t p r e s s
S Y S T E M M E N U
A u t o c h . p r o g r a m m i n g
A d d d e l e t e c h a n n e l s
V C R P l u s + c h .
T i m e D a t e