Philips 29PFL4908-F7 - Manual (Page 74)

9
Use J K to select your preferred energy efficiency level, then press
OK.
Energy saving Personal
Select the energy efficiency level you prefer.
10
Use J K to select your preferred sound setting, then press OK.
Sound C Sound B Sound A
Select your preferred sound setting
11
Press OK to finish Settings assistant.
Store Cancel
Store your preferences.
●
Network updates will appear after Connection test succeeds.
Use J K to select Yes, then press OK.
● When the initial setup is completed, the lowest memorized
channel with the confirmation message will be displayed on the TV
screen.
Note(s)
● If you are not receiving a signal from your Cable service, contact the Cable provider.
● If you press B during autoprogram, this setup of TV channels will be cancelled.
● The Initial Autoprogram function can be executed for either Antenna or Cable only once.
When you change the connection (Antenna / Cable), select Autoprogram again. L
p. 34
After an Initial Setup is completed...
●
If you want to scan the channels Automatically again.
Autoprogram L p. 34
●
You can add the desired channels not memorized by Autoprogram
through antenna connection.
Weak channel installation L p. 34
● If you want to change to another Language.
Language L p. 33
●
If you want to change the country setting.
Country L p. 47
●
If you want to change the Location setting.
Location L p. 35
● If you want to change the network setting.
Network L p. 37
●
If you want to restore the picture and sound setting.
Settings assistant L p. 27
18 .
English