Philips 27" real flat commercial TV - Manual (Page 12)

12
TV SETUP MENU & SUB-MENUS
* LANGUAGE (ENGLISH / ESPANOL / FRANCAIS) (ENGLISH / ESPANOL / FRANCAIS)
When you first enter the TV SETUP Menu, LANGUAGE is highlighted. Scroll to the LANGUAGE item, select other languages with
the Æ or Í button on the remote control.
* CHANNEL INSTALL >
When selected, CHANNEL INSTALL menu appears. Configure
the inputs and channels as seen here.
>
TV Setup - Channel Install (Commercial Mode)
CHANNEL INSTALL
CHANNEL TV 2-125 / AV2 / SIDE / S-VIDEO / CVI / DIGITAL
INPUT ANTENNA / AV2 / SIDE / S-VIDEO/ CVI / DIGITAL
AUTO PROGRAM
CHANNEL RING
SAVED / DELETED
LABEL MYLABEL >
VIDEO BLANK NO / YES
AUDIO MUTE NO / YES
INPUT
1
Select the channel or input you wish to configure.
2
Select the channel or input you wish to associate
with the specific CHANNEL. This feature enables
2
you to "map" (re-assign) a numeric channel number to
2
a video input, rather than to its normal RF TV channel
(i.e. ANTENNA) channel 2.
Note : Although it is possible to map a given video source (eg CVI) to
another video source (eg. S-VIDEO) this is not advisible as it may lead to
confusion.
AUTO PROGRAM
1
When AUTO PROGRAM is selected, the TV performs an
automatic search for the presence of viable RF signals at
its tuner input. An AUTO PROGRAMMING ACTIVE
TABLE of active numbers will appear. When a viable signal
is detected on a given channel, that channel is highlighted in
red and is added to the channel ring.
2
If CABLE TUNING is set to CABLE TUNING CABLE TUNING NO, channels 2 through 69 will
be checked. When a viable signal is detected on a given
channel, that channel is highlighted in red and is added to the
channel ring.
3
Pressing any key on the remote control will terminate the
AUTO PROGRAM session.
AUTO PROGRAM
AUTO PROGRAMMING ACTIVE
1 2 3 4 5 6 7
8 9 10 11 12 13 14
15 16 17 18 19 20 21
22 23 24 25 26 27 28
29 30 31 32 33 34 35
36 37 38 39 40 41 42
43 44 45 46 47 48 49
50 51 52 53 54 55 56
57 58 59 60 61 62 63
PRESS ANY KEY TO STOP
DIGITAL CHANNEL SEARCH : 22
CHANNEL RING
Specify whether the current channel or input is to be SAVED or SKIPPED from the channel ring (i.e. list of channels available for
selection with a guest remote control).
LABEL
Input a maximum number of 8 characters for the channel's label. Press cursor Æ to start the first character. Cursor Æ or Í to
navigate between character positions within the label field. Cursor Î or ï
or or to select characters from the list A-Z or 0 - 9 etc.
To exit, press cursor Æ or Í to navigate out of the label editing field.
VIDEO BLANK
If VIDEO BLANK is set to NO. Video will be displayed.
If VIDEO BLANK is set to YES. Video will not be displayed.
AUDIO MUTE
If AUDIO MUTE is set to NO. The current channel is audible.
If AUDIO MUTE is set to YES. The current channel is muted
* CABLE TUNING ((NO / YES) NO / YES)
If CABLE TUNING is set to NO. You are selecting standard off-air tuning
If CABLE TUNING is set to YES. You are selecting cable offset tuning.