Philips Fidelio SoundBar Home theater HTL7180 4.1 CH wireless surround sound Bluetooth® 2 HDMI In & HDMI out ARC Aluminium - Manual (Page 9)

8 EN
3 Connect and set
up
This section helps you connect your SoundBar
to a TV and other devices, and then set it up.
For information about the basic connections of
your SoundBar and accessories, see the quick
start guide.
Note
• For identification and supply ratings, see the type plate
at the back or bottom of the product.
• Before you make or change any connections, make sure
that all devices are disconnected from the power outlet.
Charge speakers
If the wireless surround speaker is undocked
from the main unit, its battery level is indicated
by the indicator on the speaker.
• Light up white: full battery
• Light up red: low battery level (less than
30% remaining)
• Flash red: near empty (less than 10%
remaining)
1
Dock your speakers onto the main unit to
charge the speakers.
2
Turn on the main unit.
» During charging, the indicator on the
speaker lights up amber.
» When fully charged, the indicator on
the speaker lights up white for 30
seconds.
Note
• It may take around 2 hours to fully charge the speakers.
• If the charging lasts more than 4 hours during standby
of the main unit, the speakers automatically switch to
standby.
Pair up with speakers/
subwoofer
The wireless speakers and subwoofer
automatically pair up with the SoundBar for
wireless connection when you turn on the
SoundBar, the speakers and the subwoofer.
If no audio from the wireless speakers and
subwoofer can be heard, manually pair up the
speakers and the subwoofer.
Pair up with the speakers
1
Turn on the SoundBar and the surround
speaker.
» If the connection to the SoundBar is
lost, the indicator on the speaker blinks
red slowly.
2
Press the Connection key on the speaker
with a pin to enter the pairing mode.
» The indicator on the speaker blinks
red quickly.
3
On the remote control, press AUX, and
then press TREBLE -, BASS + and +
(Volume) within three seconds.
» If the pairing succeeds, the indicator on
the speaker lights up white (undocked
from the main unit), or the indicator
on the speaker lights up white for 30
seconds (being docked into the main
unit).
» If the pairing fails, the indicator on the
speaker blinks red slowly.
4
If the pairing fails, repeat the steps above.
HTL7180_F7_UM_V2.0.indb 8 2013/10/22 10:49:21