Philips 40PFL4709-F7 - Manual (Page 15)

These Operations are accessible by Remote Control.
Some may also be accessible by the Main Unit's Control Panel.
Initial Setup
This section will guide you through the Unit’s Initial setting which includes
selecting a Language for your On-screen Menu and Autoprogram, which
Automatically scans and memorizes viewable channels.
Before you begin:
Make sure the Unit is connected to an Antenna or Cable.
1
After making All the Necessary Connections, press B to Turn On
the Unit.
●
It may take a few moments to Turn On the Unit for the first time.
●
Initial setup menu appears Automatically after the Unit is Turned
On.
2
Use H I to select the On-screen language from the choices
(English / Español / Français) on the right side of the TV screen, then
press OK.
3
Use H I to select Antenna for TV channels or Cable for CATV
channels, then press OK.
Skip Back OK Select
Skip
Cable
Antenna
ANTENNA IN
Or
Cable
Antenna
Select your signal source.
jack.
Make sure the antenna is connected to "ANTENNA IN"
Initial setup
–
When Antenna is selected, the TV detects Antenna signals. It
searches for DTV and Analog TV channels available in your area.
–
When Cable is selected, the TV detects signals supplied by
Cable. It searches for DTV, Analog TV and Cable channels
available in your area.
●
Autoprogram will begin.
Skip
0 ch Analog channels
0 ch Digital channels
0%
complete.
Auto programming may take more than 20 minutes to
Please wait while the system is scanning for channels.
Initial setup
4
Use H I to select the desired Location setting, then press OK.
Home is the ENERGY STARN qualified setting.
OK Select
Home
Retail
Initial setup
In the Retail store mode, all settings are fixed.
and is ENERGY STAR qualified.
Location Home is recommended for normal home use
●
Select Home, the Unit is set to maximize the energy efficiency for
home setting and it can be adjusted through a choice of Picture
and Sound quality according to your preference. Use this setting
to remove the E-sticker, if visible on the display. L p. 31
●
You must set Home in step 4. Otherwise, Picture and Sound
settings you adjusted will not be memorized after the Unit goes
into Standby mode.
●
When the Initial setup is completed, the Lowest Memorized
Channel with the confirmation message of the Location setting will
be displayed on the TV screen.
●
Select Retail, the Unit will be set up with predefined settings for
retail displays. In this setting, the Power Consumption may possibly
exceed the limited requirement limit of the ENERGY STARN
qualification.
5
When you select Home, press OK to begin Settings assistant.
Exit Back Next
Star qualified.
The energy consumption in the “Standard” setting is Energy
you with the Left/ Right keys.
and left side differ. Select the side that is most pleasing to
You will see a series of test pictures where the right side
Settings assistant helps you customize picture settings.
Settings assistant
6
Press J or K 3 times to select the side of the pictures that is the
most pleasing to you, then press OK.
Exit Back Next Select
1/3 Select the picture setting that you prefer.
Right side Left side
15 .
English