Philips 40PFL4709-F7 - Manual (Page 24)

Setup
Before you begin:
Make sure the Unit is connected to Antenna or Cable.
1
Press Q and use H I to select Setup, then press OK.
Antenna
Add channels
Channel list
Autoprogram
USB
Language
Features
Setup
Sound
Picture
2
Adjust the following items.
Autoprogram
Be sure the RF cable is correctly connected to this Unit and you are
registered with your Cable TV provider when you Install Cable channels.
1
Use H I to Select Autoprogram, then press OK.
●
If you run Autoprogram when you have Locked Channels, a
Message appears asking to enter your PIN. Enter your PIN in order
to Complete the Installation. You need to reset or set the Channel
Lock again after the Installation.
2
Use H I to Select an appropriate Option, then press OK.
–
When Antenna is selected, the TV Detects Any Off-the-Air
Antenna Signals. It searches for ATSC (Digital) and NTSC
(Analog) Channels available in your Area.
–
When Cable is selected, the TV detects signals supplied by
Cable. It searches for DTV, Analog TV and Cable channels
available in your area.
Cable
Antenna
Back
ANTENNA IN
Or Cable
Antenna
Select your signal source.
Language
Features
USB
Setup
Sound
Picture
than 20 minutes to complete.
Auto programming may take more
Auto program will rescan all channels.
Exit
6 ch Analog channels
10 ch Digital channels
75%
to complete.
Auto programming may take more than 20 minutes
channels.
Please wait while the system is scanning for
Autoprogram
●
When the Scanning and Memorizing of Available Channels is
Completed, the Lowest Memorized Channel will be Displayed.
Note(s)
● After setting Autoprogram, using CH + / – skips unavailable channels Automatically.
● If you are not receiving a signal from your Cable service, contact the Cable provider.
● If you press B or Q during Autoprogram, the Setup of TV channels will be Cancelled.
● Even if Autoprogram is completed, the channel setting will be lost if the AC Power Cord
is unplugged before the Unit goes into Standby mode by pressing B.
● The PIN Code will be required Once you set a PIN code in the Child and Ratings Lock.
L p. 27
● If you want to change your PIN code, follow the instruction for Change PIN. L
p. 29
Channel list
The channels selected here can be skipped when selecting the channels
using CH + / –.
Those channels can still be selected with the NUMBER keys.
1
Use H I to select Channel list, then press OK.
2
Use H I to select the channel you want to remove, then press
OK.
DTV
DTV
DTV
11.1
11.2
11.3
Back Watch / Skip Ch Select
key selection.
Highlight channels for Ch Up/Down
USB
Language
Features
Setup
Sound
Picture
●
The channel display for the removed channel darkens. You will not
be able to select the channel again using CH + / –.
● To reactivate a removed channel, use H I and press OK. The
registered channels are highlighted.
● When you remove a main channel, its subchannels are removed
as well.
Note(s)
● The channel with DTV indicated on the display is ATSC. Otherwise the channel is Analog
TV (NTSC).
24 .
English
Continued on next page.