Philips 20RF40S - Manual (Page 5)

5
75 ⍀
OUTPUT INPUT
5
6
3 4
75 ⍀
1
2
Y our Cable TV input into your home may
be a single (75 ohm) cable or a converter
box installation. In either case, the connec-
tion to the TV is very easy. Follow the steps
below to connect your cable signal to your
new television.
If your cable signal comes directly from a
round 75
Ω
coaxial cable use the following
steps:
1 Connect the open end of the round
Cable Company supplied cable to the
75
Ω
input on the TV. Screw it down fin-
ger tight.
2 Plug the television in to the wall outlet
and turn the TV on. Refer to the AUTO-
PROGRAM feature to program all the
available channels on your cable signal.
If your cable signal comes from a cable
box, use the following steps:
3 Connect the open end of the round
Cable Company supplied cable to the
cable signal IN(put) plug on the back
of the Cable Box.
4 Using a separate round coaxial cable,
connect one end to the OUT(put) plug
on the back of the Cable Box.
5 Connect the other end of the round
coaxial cable to the 75
Ω
input on the
back of the television. Screw it down
finger tight.
6 Plug the television in to the wall outlet
and turn the TV on. Refer to the TUNER
and AUTOPROGRAM features on page
3 of this Quick Use Guide. TUNER
should be set to the CABLE option.
AUTOPROGRAM can be set to program
all the available channels on your cable
signal into the television’s memory.
B
ASIC
C
ABLE
T
ELEVISION
C
ONNECTION
After using the AutoProgram Control, press
the CH + and – buttons to scroll through all
the channels stored in the television’s mem-
ory.
c c C
HECK
I
T
O
UT
BACK OF TV
Direct Cable Connection:
Cable Box Connection:
Cable signal coming from
Cable Company (Round
75
Ω
coaxial cable)
Jack Panel Back of TV
AC Power
Wall Outlet
Power Plug
from back of TV
Jack Panel Back
of Cable Box
Cable Signal
IN from the
Cable
Company
Round 75
Ω
Coaxial Cable
Jack Panel Back of TV
AC Power
Wall Outlet
Power Plug
from back of TV