Philips AJ6111-37 - Manual (Page 9)

9
English
Installation
Using the remote control
IMPORTANT!
– Remove the
protective plastic tab
before using the
remote control.
– Always point the
remote control directly towards IR area .
To replace the battery
1
Press and hold 1 as indicated
2
Simultaneously, pull the battery tray at 4
3
Remove the old batter y and put a new CR2025
battery in place
4
Put back the battery tray
CAUTION!
– Remove the battery if it is exhausted
or will not be used for a long time.
– Batteries contain chemical substances,
so they should be disposed of properly.
Setting the clock
The time is displayed using the 12-hour clock.
1
On the set, press and hold CLOCK
➜
The hour digits start flashing (AM
12: 00 by
default)
2
Hold down or press
∞
or
§
repeatedly to set
the hour
3
Press CLOCK to confirm the setting
➜
The minute digits star t flashing
4
Repeat step 3 to set the minute
5
Press CLOCK to confirm the setting
➜ The clock shows the set time
To turn on the Daylight Saving Time
(DST) mode
1
In the standby mode, press and hold DISP on
the set
➜ Current time setting moves ahead by 1 hour.
DSTappears
2
Press DISP again
➜ The set returns to normal time setting.
DSTdisappears
1
3
2
CR 20 25 LI T H IU M
CR 20 25 LIT HIUM
Perchlorate Material-special handling may apply,
See www.dtsc.ca.gov/hazardouswaste/
perchlorate.
p001-p018_AJ6110_37-Eng 2009.1.10, 14:22 9