Philips 27RF50S99 - Manual (Page 33)

33
R
EMOTE
U
SE WITH
A
CCESSORY
D
EVICES
- S
EARCH
M
ETHOD
06
07
08
09
06
07
08
09
1
4
07
08
09
2
VOL
3
3
Y our TV remote can be set to work
various external devices such as
VCRs, Cable Boxes, Satellite Receivers,
DBS, DVD, etc. by what is called the
search method of remote control pro-
gramming.
If the “Remote Code” number method
shown on pages 33 did not set your
remote to work your external device,
then follow the easy steps listed below.
Please read steps 1-4 before beginning.
Press the POWER button on the
device your are attempting to program
to turn it ON.
Place the TV/VCR/ACC Mode
Switch in the proper position.
Press the VCR • RECORD and
the AUTO SOUND buttons simulta-
neously and hold them down.
The device will begin to change
channels after the remote identifies the
correct code. When the channels start to
change release the VCR • RECORD
and AUTO SOUND buttons. The
remote should be ready to operate the
device.
Cable Converter
Satellite Receiver
VCR
This method can take up to
two minutes to perform.
Don’t let the device scan up more than
five channels. If you do the remote may
pass up the right code and another two
minute search cycle will have to be
repeated.
If no channel change happens within two
minutes, repeat steps 1-4. Should a chan-
nel change still not occur, the remote
will not work the desired device.
NOTE: Setting up the remote is for use
with external accessory devices only and
not for use with other television brands.
S MART H ELP