Philips 32RF50S - Manual (Page 43)

43
R
EMOTE CONTROL
– O
PERATING
A
CCESSORY
D
EVICES
(C
ODE
E
NTRY
)
SLEEP
TV/VCR
SOUND PICTURE
MENU
CH
MUTE
MULTIMEDIA CC CLOCK
POWER
VOL
STATUS/EXIT
SURF
PROGRAM
LIST
INCR.
SURR.
VCR
RECORD
VCR
TV
ACC
A/CH
1
2
3
4
SLEEP
POWER
STA TUS/EXIT
CC
CLOCK
PROGRAM
TV/VCR
PICTURE
VOL
CH
MUTE
MENU
SOUND
A/CH
MUL TIMEDIA INCR.
SURR.
A/CH
LIST VCR
RECORD
SURF
5
F ollow these simple steps to
enter a three-digit Accessory
Device Code Number that will
allow you to use your TV remote
to work the functions of an acces-
sory device. Please read through
the steps once before performing
them.
Look up a three-digit
Accessory Device Code Number
for the accessory device (found
on pages 45–46) whose functions
you want to work with your
TV’s remote control.
Press the VCR RECORD
button on the remote control and
release.
Press the SOUND button on
the remote within 30 seconds,
then release.
Enter the three-digit Direct-
Entry Code Number for your
desired device. The remote is now
ready to send commands to the
unit.
Point the remote at the remote
sensor window of the device.
Then press the POWER button on
the remote to turn the unit ON.
Enter the three-digit
Accessory Code Number for the
accessory device. The TV remote
control should now be ready to
send commands to the accessory
device.
NOTE: If the process just
explained doesn’t work the first
time, repeat the same Accessory
Device code number.
If after a second try the TV
remote control does not operate
your accessory device, see if other
three-digit Accessory Device
Code Numbers are shown for your
device on the list pages 45–46 and
repeat the steps above using a new
number.
If after repeated attempts this
method does not work for you, go
to page 44 and follow the steps
for using the Search method to set
up your remote control.
Cable Converter
BEGIN
Satellite Receiver
or DBS, etc.
VCR