Philips 4 HD HIFI SMALL CLOCK VCR - Manual (Page 9)

Playing a Tape
1
Press the VCR/TV button to put the VCR in VCR position (the
VCR light will appear on the display panel).
2
Make sure the Cable Box/DSS Receiver is on the same
channel as the VCR’s CH3/CH4 switch.
3
Use the TV channel selector to put the TV on the same chan-
nel.
4
Press the PLAY button to play the tape.
Hookups With a Cable Box/Digital Satellite System (cont’d) 9
IN
OUT
CH3 CH4
OUT
IN
ANT
R
L
VIDEO
IN OUT
IN OUT
AUDIO
This connection allows you to program an unattended recording of more than one unscram-
bled channel and to watch one channel while recording another. After you connect the VCR,
Cable Box/Digital Satellite System, and TV as shown below, the features on this page will be
available.
Recording One Channel/Watching Another
1
Put the Cable Box/DSS Receiver on the same channel as the VCR’s
CH3/CH4 switch. Put the TV on the same channel.
With the VCR in VCR position (the VCR light will appear on the dis-
play panel), use the CHANNEL (Up/Down) buttons at the VCR to
select the channel you want to record. Start the recording.
2
Press the VCR/TV button once to put the VCR in TV posi-
tion. (The VCR light will disappear.)
3
Use the TV channel selector to put the TV on the Cable
Box/DSS Receiver output channel (channel 03 or 04).
4
Select the channel you want to watch at the Cable Box/DSS
Receiver.
• You cannot record scrambled
channels with this connection.
Helpful Hint
1. Connect a Cable
signal to the VCR’s
ANT(enna) IN Jack.
3. Use a second RF coaxial cable to connect the OUT Jack on the Cable
Box/DSS Receiver to the ANTENNA IN Jack on the back of the TV.
2. Use an RF coaxial cable (supplied) to connect
the OUT Jack on the VCR to the IN Jack on
the Cable Box/DSS Receiver.
TV ANTENNA IN Jack